editor
TV Installation Perth: The Important Things to Consider
July 30, 2011
What You Should Look for When Going for TV Antennas Perth
July 23, 2011
Perth Antennas: The Important Things to Consider
July 16, 2011
Top Things to Look for When Getting Antennas Perth
July 9, 2011
0414 629 846
Our job was a little more complicated and required a lot of attention to detail.
Peter
Based on the specifications for your HDTV model, here is what I recommend. I hope this sticks into your budget.What model tuner / receiver would you guys recommend?I like the two tuners shown below on the Source section.The Samsung one is a little pricey but I believe it’s worth it. Includes Component video outputs, which is the same inputs your TV has. For audio includes stereo outputs and Dolby 5.1 digital output (in case in the future you want to connect your home theater to the receiver). It also includes a TV guide on the screen! The Kworld one is over 50% cheaper and it has a basic connections, Component though.Now, those two devices receive digital TV signal only but, at this point of time (two weeks before the digital transition), I believe is okay for you to not get analog channels.What model indoor antenna would you guys recommend?Based on your ZIP code, most of the digital channels broadcasting antennas are around 15 miles from your ZIP code (for a more exact location of the antennas go to the third link shown on the Source section below) so you could do just right with a pre-amplified indoor VHF/UHF antenna. I strongly recommend the antenna shown on the fourth link below.Now, if you already have a VHF/UHF outdoor antenna on the roof of your house and it’s in good condition, save the money and just plug it to the receiver.What cables / connectors would you guys recommend, unless the hardware comes with the right cables?Your TV has three different type of video connections: composite, S-video and Component. In order to get the best results out of the receiver and your TV, you should use the Component cables. These are three RCA cables put together in a single line and the terminals are colored (green, blue and red).For audio you can use standard RCA audio cables (red and white).Now, RCA cables transport analog signals (video/audio) so they are susceptible for radio interference so you might want to spend a little more money on some good quality cables. You can try first some cheap ones and, if the video quality is not too good, then go for something like Monster cables.Anything else I would need?Finally, if you don’t have one already, I suggest to connect the receiver and you TV to a surge protector. If you can buy one for audio/video devices would be better since those have special filters that can really improve the image and sound of the devices but if you don’t want to spend to much money in this just make sure the surge protector has enough joules for one TV and and audio device.If you are going to use an outdoor antenna, then get a surge protector that includes coaxial connections, with this you can connect the antenna to the protector and the protector to the coaxial input of the receiver. This way the whole setup is protected against thunderstorms.Uff! I think this is it. I hope this information helps.
Based on the specifications for your HDTV model, here is what I recmomend. I hope this sticks into your budget.What model tuner / receiver would you guys recmomend?I like the two tuners shown below on the Source section.The Samsung one is a little pricey but I believe it's worth it. Includes Component video outputs, which is the same inputs your TV has. For audio includes stereo outputs and Dolby 5.1 digital output (in case in the future you want to connect your home theater to the receiver). It also includes a TV guide on the screen! The Kworld one is over 50% cheaper and it has a basic connections, Component though.Now, those two devices receive digital TV signal only but, at this point of time (two weeks before the digital transition), I believe is okay for you to not get analog channels.What model indoor antenna would you guys recmomend?Based on your ZIP code, most of the digital channels broadcasting antennas are around 15 miles from your ZIP code (for a more exact location of the antennas go to the third link shown on the Source section below) so you could do just right with a pre-amplified indoor VHF/UHF antenna. I strongly recmomend the antenna shown on the fourth link below.Now, if you already have a VHF/UHF outdoor antenna on the roof of your house and it's in good condition, save the money and just plug it to the receiver.What cables / connectors would you guys recmomend, unless the hardware comes with the right cables?Your TV has three different type of video connections: composite, S-video and Component. In order to get the best results out of the receiver and your TV, you should use the Component cables. These are three RCA cables put together in a single line and the terminals are colored (green, blue and red).For audio you can use standard RCA audio cables (red and white).Now, RCA cables transport analog signals (video/audio) so they are susceptible for radio interference so you might want to spend a little more money on some good quality cables. You can try first some cheap ones and, if the video quality is not too good, then go for something like Monster cables.Anything else I would need?Finally, if you don't have one already, I suggest to connect the receiver and you TV to a surge protector. If you can buy one for audio/video devices would be better since those have special filters that can really improve the image and sound of the devices but if you don't want to spend to much money in this just make sure the surge protector has enough joules for one TV and and audio device.If you are going to use an outdoor antenna, then get a surge protector that includes coaxial connections, with this you can connect the antenna to the protector and the protector to the coaxial input of the receiver. This way the whole setup is protected against thunderstorms.Uff! I think this is it. I hope this information helps.